Fig. 5.43
Fig. 5.44
Fig. 5.45
RELAY SELF STARTER (STARTER RELAY)
l
Relay self starter is located on the right side of
the vehicle on top of the air cleaner assembly.
(Fig. 5.43)
l
Inspect relay by checking the continuity using
pocket tester.
RELAY CONDITION
Gr
R
NOT ENERGIZED
ENERGIZED
O
O
(To energise the starter relay keep the vehicle in
neutral condition, press and hold the starter
switch with the ignition lock and engine kill
switch ‘ON’ condition.)
l
If there is no continuity found, replace the
starter relay and once again check for
continuity. Again problem persists, then
replace the TCI unit and check.
BULBS REPLACEMENT
LAMP ASSEMBLY TURN SIGNAL - BULB
l
Remove the self tapping screw from turn
signal lamp housing and take off lens along
with the holder assembly and bulb. (Fig. 5.44)
Phillips head screw driver
l
Rotate and pullout the bulb holder from the
housing and replace the bulb with a new one.
(Fig. 5.45)
Turn signal lamp
12V, 10W
l
Reassemble the parts and tighten the self
tapping screw.
l
Same procedure can be followed for replacing
the turn signal lamps bulbs.
TVS APACHE RTR 200
SERVICE MANUAL
ELECTRICAL SYSTEM
5-19
