Fig. 2.6
Fig. 2.7
Fig. 2.8
FUEL TANK COMPLETE
REMOVAL
l
Remove the seats and cover frame assembly
as explained earlier.
l
Turn fuel cock knob to ‘OFF’ position and
disconnect the fuel hose from the carburettor
assembly. (Fig. 2.6)
Nose plier
l
Remove the hexagonal screw (M6x38 - 2 nos.)
along with plain washers from the fuel tank
rear mounting. (Fig. 2.7)
10 mm spanner
Tightening torque
10 ± 2 Nm
l
Remove the cushion fuel tank rear upper
(2 nos.)
l
Carefully lift the rear portion of fuel tank and
disconnect the fuel sender unit wiring socket.
(Fig. 2.8)
l
Take out the cushion fuel tank rear lower
(2 nos) from the fuel tank mounting.
l
Remove fuel tank complete along with drain
hose by sliding it out from both the cushion fuel
tank front.
Note:
While reassembling fuel tank complete,
ensure that fuel sender unit wiring socket
is connected and fuel tank drain hose is
routed properly.
Ensure the fitment of both lower and upper
fuel tank cushions rear and proper seating
of the fuel tank at cushion fuel tank front
during reassembly.
TVS APACHE RTR 200
SERVICE MANUAL
PERIODIC MAINTENANCE
2-5
