l
Remove the hexagonal flange bolt (M6x20 -
1 no.) mounting the pipe complete inlet with
the crankcase assembly R. (Fig. 2.56A)
l
Remove the hexagonal flange bolts (M6x16 -
2 nos.) mounting the pipe complete inlet with
the oil cooler assembly. Dislocate and take out
the pipe complete inlet. (Fig. 2.56B)
8 mm spanner
Tightening torque
10 ± 2 Nm
l
Remove the hexagonal flange bolts (M6x25 -
2 nos.) from the oil cooler assembly mounting
and take out the oil cooler assembly. (Fig. 2.57)
10 mm spanner
Tightening torque
10 ± 2 Nm
Oil cooler assembly fins
Inspect and clean at 6000 km first and
every 3000 km thereafter.
l
Gently dislocate the guard oil cooler along with
cup washers from the oil cooler assembly.
(Fig. 2.58)
l
Visually inspect the oil cooler fins for any
blockage.
l
If found any, clean them using a small blend
tool and compressed air.
Caution:
Care should be taken not to damage the
fins while cleaning with the tool and
compressed air.
l
Inspect the oil cooler fins (A) for any
deformation. If it so, straighten them with a
thin, flat head screw driver. (Fig. 2.59)
Note:
If the air passages of the cooler assembly
a r e b l o c k e d m o r e t h a n 2 0 % b y
unremovable objects or if the fins of the
cooler are un-repairable, replace the cooler
assembly with a new one.
TVS APACHE RTR 200
SERVICE MANUAL
PERIODIC MAINTENANCE
2-22
Fig. 2.56A
Fig. 2.56B
Fig. 2.57
Fig. 2.58
Fig. 2.59
A
