The Apache RTR 200 Fi4V with ABS does an
automatic self check every time the ignition switch is
turned ‘ON’. The ABS warning lamp provided at the
speedometer console blinks and informs you that the
ABS is under check.
This ABS warning lamps goes ‘OFF’ once the bike
reaches 10 km/h speed and above, indicating that the
ABS is working fine. If the warning lamp continuously
‘ON’ even after the vehicle crossing 10 km/h speed
then ABS has an error and your bike should be taken to
any of your nearest TVS Motor Company Authorised
Distributor or Dealer / Authorised Service Center.
DO‘S AND DON'T‘S
Do’s
t
Check the ABS warning lamp for any warning
before driving the vehicle.
t
Apply both front and rear brake for better
performance.
t
Apply continuous brake in ABS mode for better
performance. Do not pump.
t
Perform the periodic maintenance as per the
schedule.
t
ABS should be serviced only at TVS Motor
Company Authorised Distributor or Dealer /
Authorised Service Center.
t
Carefully remove the wheel during puncture / tyre
replacement to prevent toner ring damage / bend.
ANTI-LOCK BRAKE SYSTEM
05
The ABS can apply and release the pressure in the
brake circuit much faster than that rider can do with
brake pedal / lever to avoid wheel locking, so there is
no need to pump the brake, it requires only
continuous application.
Warning
