25
25
4. Adjustable clutch lever
Use the clutch lever to disengage the drive to the rear
wheel while shifting the gears. Squeezing the lever
towards grip disengages the drive.
5. Pass-by switch
Press the switch to flash the head lamp high beam. It
is used to give signal to the vehicles coming from the
opposite direction while overtaking other vehicles
during day.
The pass-by works only when the head lamp is
glowing in low beam. If the switch is pressed while
the head lamp is glowing in high beam, there will be
no change in beam of head lamp.
6. Head lamp high / low beam switch
The head lamp low beam glows (low or high beam
glows based on the switch position) automatically on
starting the engine. The head lamp beam (high/low),
can be controlled using the beam control switch.
Press the top end of switch for ‘High’ beam ’ ‘ and
bottom end for ‘Low’ beam ‘ ‘.
Clutch lever position can be set to your convenience.
Refer page no. 74 for details.*
Pass by system will not work if the head lamp is glowing
in ‘High’ beam.
Note
Failure to switch the turn signal lamp ‘ON’ or ‘OFF’ at the
right time may lead to an accident.
Warning
Use appropriate head lamp beam ‘high / low’ as per the
traffic and road conditions for your safety and to avoid
inconvenience to other riders.
It is strongly recommended to ride the vehicle in ‘low’
beam during day.
Warning
The headlamp glows in low beam / high beam
automatically once the engine is started based on the
position of beam control switch.
Note
* Applicable for Connected instrument cluster version only
