HANDLE BAR RIGHT SIDE
23
1. Electric starter switch
Ensure the transmission is in neutral or else press the
clutch lever before engaging the electric starter
switch ‘ ‘. Release the electric starter switch after
the engine has started.
If the electric starter switch is pressed more than
3 seconds continuously, the starter motor gets
disabled automatically and will not crank the engine.
The motor cranks the engine only after 3 seconds
or if the switch is released and repressed again.
1
3
4
5
2
4. Pass-by switch
Press the switch to flash the head lamp. It is used to
give signal to vehicles coming from the opposite
direction while overtaking other vehicles during day.
If the pass by switch is pressed during day time when
the head lamp is in OFF condition, the head lamp
HIGH beam alone will glow with 100% of intensity.
During night time when the head lamp is in ON
condition the beam toggles automatically from HIGH
beam to LOW beam or vice versa.
If the pass-by switch is pressed with the engine in
OFF condition, the head lamp glows with 50% of
intensity only.
5. Head lamp high / low beam switch
With the head lamp in ON condition, press the top end
of switch for HIGH beam ’ ‘ and bottom end for
LOW beam ‘ ‘.
Failure to switch the turn signal lamp ON or OFF at the
right time may lead to an accident.
Use appropriate head lamp beam 'high / low' as per
the traffic and road conditions for your safety and
avoid inconvenience to other riders.
Warning
KNOW YOUR TVS RTR 200 Fi4V
