VERA RF600i Assembly Instructions
31
To set up the flown system with the subwoofer, proceed as follows:
Figure 4.15.1 - Mounting the first subwoofer
WARNING
WARNING
WARNING
4.15 Setting up the subwoofer in a flown system
1. Please note that setting up the subwoofer always requires two persons!
2. Place all subwoofer on the floor, except the last one. Place a pad under all loudspeakers
to avoid damage.
4. Insert the splay links of the subwoofer into the openings at the VERA RF600i rigging frame.
5. Attach the splay links and the brackets to the left and right side of the VERA RF600i rigging
frame using one cylinder screw, item 2 and one lock washer, item 3 from the subwoofer
scope of delivery.
6. Make sure to properly insert the lock washer as described in section 4.7!
7. Make sure that the screws with the lock washers are attached (but not tightened) to the
VERA RF600i rigging frame on the left and right side.
5.
4.
5.
NOTE
3. Use the EASE Focus simulation software to determine the amount of speakers and splay
angles required for your application.
