VERA RF600i Assembly Instructions
23
4.10 Preparing the following VERA20i loudspeakers for a flown system
Figure 4.10.1 – Attaching the splay links to the reamaining VERA20i loudspeakers
1. Start by attaching splay links on the front bottom left and right of the VERA20i loudspeaker
(item 4 on the scope of delivery).
2. Attach each splay link using one cylinder screw, item 2 and one lock washer, item 3 from
the VERA20i loudspeaker scope of delivery.
3. Make sure to properly insert the lock washer as described in section 4.7!
4. Make sure that the screws with the lock washers are only attached and not tightened.
Figure 4.10.2 – Attaching the links to the remaining VERA20i loudspeakers
5. Attach the bracket to the VERA20i loudspeaker at the angle that you previously calculated
using the EASE Focus simulation software.
6. Attach the brackets on the rear bottom left and right of the VERA20i loudspeaker (item 5
on the scope of delivery).
7. Attach each splay link using one cylinder screw, item 2 and one lock washer, item 3 from
the VERA20i loudspeaker scope of delivery.
8. Make sure to properly insert the lock washer as described in section 4.7!
9. Make sure that the screws with the lock washers are only attached and not tightened.
1.
2.
5.
7.
WARNING
WARNING
