5
Fig. 5
Fig. 4
DD
CC
CC
I
G
4. Insert one Wood Dowel (CC) into each of the
pre-drilled holes on the top edges of the Assembly
from step 3. Then locate Mantel/Top (G) and lay
fi
nished side up on top of completed assembly. From
the inside, attach Mantel/Top (G) using Bolts (AA)
and Washers (BB) through the pre-drilled holes in
the mounting blocks.
HAND TIGHTEN ONLY.
Using Phillips head screwdriver tighten all Bolts
alternating top and bottom, left and right.
5. Attach Center Back Panel (I) to the back of the
completed assembly from step 4. Use a Phillips
Head Screw Driver, tighten Wood Screws (DD)
through the pre-drilled holes in the Center Back
Panel (I).
AA
BB
Fig. 3
BB
AA
L
CC
Hardware Used
Hardware Used
BB
AA
DD
Bolt
Screw
x 2
x 16
Washer
x 2
3. Insert wood dowel (CC) into the holes in the
Left/Right Side Panel (E/F).
Push Center Front Molding (L) snug to the Left/Right
Side Panel (E/F). Using Bolts (AA) and Washers
(BB) attach panels through pre-drilled holes in the
mounting blocks.
HAND TIGHTEN ONLY.
Hardware Used
BB
AA
CC
CC
Bolt x
9
Washer x
9
Wood Dowel
Wood Dowel
x 6
x 2