Step 2
Attach the main telescope tube to the
tripod head using the photo bolt screw
as shown in Figure 2.
Figure 2 – Attaching the Telescope tube.
Step 3
Finally, insert one of your eyepieces into
the focusing tube, as shown in Figure 4,
and you are ready to begin observing. Be
sure to tighten the set screw that holds
the eyepiece in place. IMPORTANT:
There is a small flip lever next to the
eyepiece assembly. This lever lets you
observe using an eyepiece either (a)
through the back of the telescope (as
shown) or, (b) through the top of the
telescope (not pictured). Make sure the
flip lever is set parallel to the telescope
tube as shown in Figure 4 to use observe
through the back of the telescope.
Figure 3 – The angle prism screws into
the back of the telescope tube.
Step 4
Figure 4 – An eyepiece goes in the angle prism.
Screw the angle prism into the back of
the telescope.
