- 9 -
21B
3.3.3 Parameter Setup in Normal Mode
1) Voltage Setup (Vset)
In standby mode, press key “
︿
” or “
﹀
” to go to voltage setup. To input a new voltage value , dial
the numeric key pad and press ENTER to confirm the new input. If there is wrong input, press key
“
←
” to clear the wrong values and make new input. Or, press key “<” or “>” to make direct
adjustment to the current numbers.
In output mode, voltage values can also be adjusted by pressing key “<” or “>” to make direct
adjustment to the current numbers.
In output mode, the low range voltage can be set at any value between 0V to 150V, and the high
range voltage can be set at any value between 0V to 300V. If the desired output voltage is over the
low range, first switch to high range and set the desired voltage.
2) Frequency Setup (Fset)
In standby mode or output mode, press key “
︿
” or “
﹀
” to go to frequency setup. To input a new
frequency value, dial the numeric key pad and press ENTER to confirm the new input. If there is
wrong input, press key “
←
” to clear the wrong values and make new input. Or, press key “<” or
“>” to make direct adjustment to the current numbers.
In output mode, frequency values can also be adjusted by pressing key “<” or “>” to make direct
adjustment to the current numbers.
The frequency can be set at any value between 45Hz to 120Hz. If the optional range 40~500Hz is
selected, the frequency can be set at any value between 40Hz to 500Hz.
