- 12 -
The frequency can be set at any value between 45Hz to 120Hz. If the optional range 40~500Hz is
selected, the frequency can be set at any value between 40Hz to 500Hz.
4) Running Time Setup (TR)
In standby mode, press key “
︿
” or “
﹀
” to go to running time setup. To input a new voltage value,
dial the numeric key pad and press ENTER to confirm the new input. If there is wrong input, press
key “
←
” to clear the wrong values and make new input. Or, press key “<” or “>” to make direct
adjustment to the current numbers.
5) Delay Time Setup (TD)
In standby mode, press key “
︿
” or “
﹀
” to go to delay time setup. To input a new voltage value,
dial the numeric key pad and press ENTER to confirm the new input. If there is wrong input, press
key “
←
” to clear the wrong values and make new input. Or, press key “<” or “>” to make direct
adjustment to the current numbers.
6) Enable Data
In standby mode or output mode, press key “
︿
” or “
﹀
” to go to a data group. Press key “<” or “>”
to select “Enable” or “Disable” selected the data group.
Enable: to use the selected data group
Disable: to un-use the selected data group
7) Running Cycles Setup (LOOP)
In standby mode or output mode, press key “
︿
” or “
﹀
” to go to a loop setup to set the running
cycle numbers. To input the cycle numbers, dial numeric key pad and press ENTER key to confirm
the new input. If there is wrong input, press key “
←
” to clear the numbers and make new input.
23B
3.3.5 System Setup and Operation
1) Voltage Range Setup (Vrange)
In standby mode, press key “
︿
” or “
﹀
” to go to voltage range setup. Press key “<” or “>” to make
range selection between H (High) and AUTO range.
