First, you must remove the seat and completely
disconnect the battery.
Locate the four-pin accessory plug located
between the frame rails in front of the battery
and remove the cap. ( k
&
l)
Next, loosen the console on top of the gas tank
by removing the lower nut and accompanying
washer... as well as the top bolt.
Pull up gently on the console, and carefully
push the wiring harness under the rubber gasket
surrounding the console. Make sure the harness
NOTE: If you are installing on an older bike that
does not have this accessory plug, you should
obtain an additional fused battery direct harness
from Twisted Audio for your installation.
is fully inserted under the gasket from one end
of the console to the other (m). Replace and tighten
the hardware that attaches the console.
Now plug the wiring harness into the accessory
plug under the seat (n) and secure the harness to
the bike’s wiring with a tie wrap (o).
INSTALLATION · ELECTRICAL
m
n
o
Now feed the other end of the wiring harness up
through the bike’s main harness clamp — and
through the opening in the top fork cover as you see
here (p). This may take a little fiddling to achieve.
p
6
k
l
ACCESSORY PLUG LOCATION
OPENING
