(stopped lfo) Aftertouch will override the lfo and directly modulate all
parameters associated to the lfo. Use the depth knob to adjust the
amount of effect.
Above 12 o clock the setting is on, below the setting is off.
The setting is indicated by ON/OF on the numeric display
The numeric display will indicate “At” followed by “On” or “Of”
Arp sync to incoming MIDI clock
Turn the arp
rate
knob to choose whether to link the arp to the MIDI
clock.
Preset Volume on/off
Turn the volume knob to turn preset volume loading on or off.
When set to off, the preset volume will be ignored when changing preset.
Above 12 o clock the setting is on, below the setting is off.
The setting is indicated by ON/OF on the numeric display
MIDI THRU
Press the LFO1 link button to toggle MIDI THRU on/off.
When on, all incoming MIDI is sent to the MIDI output.
By default this setting is OFF.
Midi Channel ,Pitch bend up & down Learn
In setup mode you can set the input channel simply by sending MEGAfm
a NOTE ON message on any midi channel. When a new Midi channel is
registered, it is displayed on the numeric display after the letters “Ch”
MEGAfm can also learn the pitch bend ranges.
Pitch up and down can be any value from 1 to
48. Hold any key then press a key above the
first key to define the pitch bend up range or a
key key below it to define the pitch down
range (without releasing the first key).
For example if you wish for MEGAfm to bend
up 2 semitones and down 5 semitones, hold C
