TWM EXTRA 330L 60, Instruction Manual

20mm

50mm

50mm

30mm

30mm

20mm

Control Throws

C.G.

Elevator

Rudder

19

Ailerons 

120 mm

Important Safety Precautions

4.8in.

P. 11

The ideal C.G. position is 120mm (4.8 in.) behind the leading edge 
measured at where the wing meets the fuselage.  In order to obtain 
the C.G. specified, add weight to the fuselage or move the battery 
position.  Check the C.G. before flying. 

Adjust the control throws as shown in 
the diagram.  These throws are good for 
general flying.  You can adjust according 
to your personal preference.

Warning

!

# First time flyer should never fly by himself / herself.  Assistance from experienced
   flyer is absolutely necessary.

# Pre-flight adjustment must be done before flying, it is very dangerous to fly a badly 
   pre-adjusted aircraft.

#                          

is specially designed to be powered by 

2C 0.60-0.75 or 4C 0.91

engine, using a more powerful engine does not mean better performance.  In fact, 
over powered engine may cause severe damage and injuries.

# Make sure the air field is spacious, never fly the plane too close to people and never
   get too close to a running propeller.

# If you find wrinkles on the covering as a result of weather changes, you can use hot 

iron to remove the wrinkles.   Please begin with lower temperature setting and 
gradually raise the temperature until the wrinkles are gone.  Too hot an iron may 
damage the covering.  Don't use hot iron near the seams or edges, hot iron will

   melt the glue and shrink the covering at the same time, causing the seams to pull away.

# Check and re-tighten up all factory assembled screws, use thread locker if necessary.

http://www.theworldmodels.com/para/instruction/instructionManuals.php

A156SPO25891108