1210 Series Modular Interface Cables
The uses a six-pin modular receptacle for compatible serial devices only. 1210 series modular interface
cables have reversing signals and connect to the auxiliary RS-232 serial port on the JETT•RFID and a
Two Technologies’ CELAT-P adapter. For 1210 series modular interface cable signal and pin
assignments, see
Appendix B: Signal and Pin Assignments
Warning! Despite its physical similarity to modular telephone connectors, the 1210 series modular interface
cable is not compatible with telephone lines or signals. Connecting the JETT•RFID to a telephone line will
damage it and void the warranty.
To connect power to the JETT•RFID using a 1210 series modular interface cable and a CELAT-P
adaptor:
1.
Plug one end of the 1210 modular cable into the modular connector on the bottom of the
JETT•RFID. Plug the other end into the CELAT-P adapter. See
Figure A-1
.
2.
Plug the power supply connector into the CELAT-P adapter. Plug the power supply
transformer into a power outlet.
Figure A-1: Auxiliary Port Cable Connections
Modular Cable
CELAT-P Adapter
Power Supply/
Battery Charger
Bottom of Unit
JETT•RFID Technical Reference Manual, MAN0339, Rev. A, Preliminary
2-5
