If the unit does not power up or you cannot select any items from the desktop, refer to the
“
Troubleshooting
” chapter for help.
Power Off
To turn off the JETT•RFID, press and hold the ON/Off switch for approximately eight seconds. This
action will also terminate running applications and cease serial port operations).
Suspend Mode
Suspend mode allows you to suspend, but not terminate active applications. In this mode, the display
will turn off and the JETT•RFID will cease serial port operations. For battery-powered units, use of
Suspend mode also conserves battery power.
To place the unit in Suspend mode, press and release the ON/Off switch.
To take the JETT•RFID out of Suspend mode, either touch the screen or press and release any key. The
display will turn on and the JETT•RFID will resume running any suspended application, but you must
restart any serial port operations.
If you attempt to resume immediately after suspending the JETT•RFID or vice versa, the unit will
automatically delay three seconds before resuming or suspending.
Reset
To reset (warm-boot) the JETT•RFID, press and hold the ON/Off switch between three and five
seconds. The screen should turn off, and the boot-up process should start. After approximately 20-25
seconds, the Windows CE .NET desktop should appear.
Note: Holding the Power/Resume button longer than six seconds will turn off the JETT•RFID.
Operation
3-2
