14
Basin Mixer/Bidet Mixer/Mini Basin Mixer
Installation continued
(X505126CP, X505122CP, X505135CP)
Identify all components are present prior to starting
the installation.
1. Screw the flexi tails into the bottom of the mixer
body by
hand only (DO NOT OVERTIGHTEN)
.
2. Screw the fixing rods into the bottom of the mixer
body.
3. Place the plinth over the hole in the basin,
ensuring the washer is fitted between the plinth
and the basin. Feed the flexi tails through hole in
basin.
4. Slide ‘C’ shaped rubber washer and ‘C’ shaped
metal washer onto the fixing rods up to the
underside of the basin.
5. To secure the mixer in place tighten the fixing
nuts onto the fixing rods until they are fully
tightened against the ‘C’ shaped metal washer.
The fixing nuts can be tightened with a suitable
spanner.
6. Connect the flexi tails to the hot and cold water
supplies.
7. Turn on water supplies, lift the mixer handle
upwards and operate in both directions, letting
the water flow for a few minutes and purging air.
8. Fit the clicker waste ensuring a rubber washer is
fitted between the basin and the waste. Use a
pure silicon sealant where necessary. Place the
other rubber washer under the basin and secure
by tightening the backnut, in order to fill the
basin, the button in the middle of the waste
needs to be pressed down. To release the water,
press the button again.
9. Check all joints and connections for any leaks
Flexi Tails
‘C’ Shaped
Rubber
Washer
‘C’ Shaped
Metal
Washer
Fixing
Rods
Fixing
Nuts
Drawings for illustration purposes only
Plinth
For latest prices and delivery to your door visit MyTub Ltd - www.mytub.co.uk - info@mytub.co.uk