TINYOM / HELYOMBT UTILITIES USER GUIDE
9
3.
Connect the Bluetooth device to TXcom reader.
Starting / Turning off
Starting
For the Tinyom, press lightly on the touch sensor during one second.
For the HelyomBT, press the trigger button during 1 second.
Turn off
The TXcom reader turns off:
•
Automatically after a configurable delay without activity,
this delay is set to 1 hour by default,
•
By a long touch of roughly 2 seconds on the sensor when the
long touch triggering mode is set to ON/OFF (See Trigger
setting on page 21),
•
For the Tinyom, by a long touch greater then 7 seconds and
after that the 3 LED green, red, blue flash briefly.
Operating
The laser reading is triggered by the activation of the touch sensor or
the motion sensor for the Tinyom, by the trigger button for the
HelyomBT or by radio for both.
Read could be one-shot mode or burst mode.
1.
Start the laser scanner.
2.
Aim the laser window on the bar code label to read.
Hold the laser scanner at a slight angle to the bar code, other than
perpendicular.
