2.7 Finishing
Up
2.7.1
Put the top cover back on and fasten
the thumb screws in the back of the
chassis.
Congratulations on making it this far! You’re finished setting up the hardware aspect of
your computer. Before closing up your chassis, make sure that all cables and wires are
connected properly, especially IDE cables and most importantly, jumpers. You may
have difficulty powering on your system if the motherboard jumpers are not set
correctly. For detailed M/B jumper settings, please refer to S2723/ Tiger i7501 M/B
user’s manual.
In the rare circumstance that you have experienced difficulty, you can find help by
asking your vendor for assistance. If they are not available for assistance, please find
setup information and documentation online at our website or by calling your vendor’s
support line.
15
http://www.tyan.com