34
http://www.TYAN.com
4.
Use the command
uname –r
to check which kernel the system is using. If the kernel
is
2.4.18-5smp
, modify the file
/boot/kernel.h
as follows:
#define __BOOT_KERNEL_SMP 1
If you are using the SMP kernel, in order to allow a complete system shutdown, then
perform the following:
1.
M
odify
the
/boot/grub/ grub.conf
by adding the
boot parameter
apm=power_off
.
Then save and exit.
2.
Run the command
grub-install /dev/hda
, then reboot the system.
Next, proceed to the following driver installations.
LAN Driver
1.
Insert the driver CD into the CD drive.
2.
Copy the base driver tar file
e1000-5.2.16.tar.gz
of the
/LAN/Intel/LINUX/
directory to the directory of your choice. For example,
use
/home/username/e1000
or
/usr/local/src/e1000
.
3.
Untar/unzip archive:
tar zxf e1000-5.2.16.tar.gz
.
4.
Change to the driver src directory:
cd e1000-5.2.16/src/
.
5.
Compile the driver module:
make install
The binary will be installed as:
/lib/modules/[KERNEL_VERSION]/kernel/drivers/net/e1000.o
The installation locations listed above are the default ones. They might not be correct
for certain Linux distributions. For more information, refer to the
ldistrib.txt
file included in the driver tar.
6.
Install the module:
insmod e1000 <parameter>=<value>
.
7.
Assign an IP address to the interface by entering the following, where
x
is the
interface number:
ifconfig ethx <IP_address>
.
8.
Verify that the interface works. Enter the following, where
<IP_address>
is the IP
address for another machine on the same subnet as the interface that is being tested:
ping <IP_address>
.
9.
To ensure that the NICs function properly when system starts, add the following in the
/etc/modules.conf
directory:
alias eth0 e1000
alias eth1 e1000
.
Summary of Contents for B5103G12S2
