Tiger i7320 / Tiger i7320R Chapter 4: SATA/RAID Setup
4-5
http://www.tyan.com
Note
Before adding a new drive to an array, back up any data contained on the
new drive. Otherwise, all data will be lost.
A RAID 1 created using the Quick Init option may return some data
miscompares if you later run a consistency check. This is normal and is not
a cause for concern.
The Adaptec RAID Configuration Utility allows you to use drives of different
sizes in a RAID 1. If you choose the smaller drive as the second drive, you
will be warned about the risk of data loss.
Warning
Do not interrupt the creation of a RAID 0 using the Migrate option. If you
do, there is no way to restart and no way to recover the data that was on
the source drive.
When you are finished, press
Done
.
4.6 Add/Delete Hotspare
===Adaptec SATA HostRAID Controller #0 Array Configuration Utility===
Display, Add, Delete hotspare
Create a drive spare:
1.
Select option Add / Delete Hotspare and press the <Enter> key to create the drive spare.
The following prompt is displayed:
Do you want to create a spare? (Yes/No):
2. Press
Y
to create the drive spare.
3. Press
Esc
to return to the previous menu.
Delete a drive spare:
1.
Select option Add / Delete Hotspare and press the <Enter> key to delete the drive spare.
The following prompt is displayed:
Do you want to delete the spare? (Yes/No):
2. Press
Y
to delete the drive spare.
3. Press
Esc
to return to the previous menu.
Main Menu
Manage Array
Create Array
Add/Delete Hotspare
Initialize Drives
