48
S1564-001-01 www.tyan.com
w
Primary/Secondary Master
w
Primary/Secondary Slave
Select one of these hard disk drive icons to configure the drive named in the
option. WINBIOS supports up to four IDE hard disk drives: the primary
master, primary slave, secondary master and secondary slave. If the hard
disk drive is an IDE drive, select DETECT PRIMARY or DETECT SLAVE
from the Utility Setup Option Section of the WINBIOS Setup Main Menu
to have WINBIOS automatically detect the IDE drive parameters and re-
port them to this screen.The SCSI option or none must be selected if a
SCSI Disk Drive is installed.For CD-ROM drives you should use none.
You can also manually enter the hard disk drive parameters. Hard disk type
47 is the user-definable drive type. The drive parameters are: Type, Cylin-
ders, Heads, Write precompensation, Landing Zone, Sectors and Capacity.
w
Floppy Drive A:
w
Floppy Drive B
:
Move the cursor to these fields via the up and down arrow keys and select
the floppy type. The settings are 360 KB 5 1/4 inch, 1.2MB 5 1/4 inch,
720MB 3 1/2 inch, 1.44MB 3 1/2 inch and 2.88MB 3 1/2 inch..
5.2 Advanced Setup
The WINBIOS Setup options described in this section are selected by
choosing the Advanced Setup Icon from the WINBIOS Setup Main
Menu.
w
Quick Boot
When enabled the BIOS will skip the memory test and will not access
the floppy drive during POST. When enabled the BIOS does a memory
test and will access and verify floppy drive types.
The default is Enabled.
w
BootUp Sequence
This option let the user specify in what sequence the BIOS will look for
a boot device. Options are
A:C:, CDROM, C:A:,CDROM or
CDROM,C:A:. The default is C:A:,CDROM.