19
S1684S/SA-001-02
Chapter 3: CPU Installation and Removal
Pentium II (233 through 300MHz) and Pentium Pro Processors (150 through
200 MHz) can be used on the S1684S/SA board. Please refer to section 2.3
for the correct CPU jumper settings for your board.
The S1684SA board provides a slot for the Pentium II Processor. (Refer to
the layout on Page 10.)
Caution!!
The CPU is a sensitive electronic component which can be easily
damaged by static electricity. Do not touch the CPU contacts with your fingers.
3.1 Installation of the Pentium II Boxed (Active) Processor
(Note: An Active Processor is equipped with a cooling fan. When installing an
Active Processor, you need to connect it's power cable to the cooling fan
connector located on the board.)
Installing the CPU Retention Module
1. Installation of a Pentium II Active Processor requires a CPU Retention
Module, which is first secured onto the motherboard. (Refer to the
motherboard layout on Page 10.)
2. To attach the Retention Module, place the motherboard on a flat
surface.
3. Locate the key pin on one end of the Pentium II Slot on the board.
Then carefully line up the key notch
on the Retention Module with the
key pin on the Pentium II Slot. (The
key pin on the Pentium II Slot
indicates the correct orientation of
the CPU.)
Pentium II Slot Connector
and Key Pin
