http://www.tyan.com
22
Chapter 2
Board Installation
Figure 2-3
To install your DIMMs, line your module up so that the pins fit into the slot.
There is only one way that your DIMM can fit properly. Make sure that the
short row of pins is lined up with the short gap in the DIMM slot. Figure 2-3
above shows how to sit the DIMM into its slot. To insert the DIMM, push
down vertically on the module with even force, as shown in the photo. Do not
shove one end in first; doing so will bend the DIMM pins.
To lock the DIMM into place, push the plastic clips on either end of the slot
onto the notches in the ends of the DIMM (see Figure 2-4 on the next page).
In some cases, pushing the memory module into the DIMM slot will move the
plastic clips inward, automatically locking the module into place. To remove
your DIMM, simply pull the clips back, and pull up on the module.
Place the DIMMs in an antistatic bag as soon as you remove them to avoid
static damage.
!!!!!
important!
