17
http://www.TYAN.com
Memory Pair Installation
When installing DIMM modules, you must install pairs in this order:
B1 + B2 or A1 + A2.
Note:
If your board only has two DIMM slots (S2722-1U), you must insert a module in
each slot.
Both modu les must be the same in both size and density. Modules must also use the same chip
configuration, as in each module that is installed must physically have the same number of
memory chips on them.
Points to remember:
•
At least TWO Registered ECC DDR SD RAM modules must be
installed for the system to turn on and POST (Power On Self
Test).
•
Use ONLY x8 or x4 type memory modules. Mixing memory types
affects stability.
•
128MB, 256MB, 512MB, 1GB, and 2GB Registered ECC
PC2100/PC1600 DDR SDRAM memory modules a re supported
in x4 or x8 configuration.
•
The Tiger i7500 S2722 supports up to 8GB of memory with 2GB
registered DDR modules.
