Appendix III: LSI Logic Config Utility
NOTE:
This appendix just provides a brief introduction of the LSI Logic
integrated RAID solution for LSI Logic controller LSISAS 1068E.
For detail of SAS RAID (TN27-B4987), please visit
http://www.Lsilogic.com/contacts/index.html
to refer to LSI manual.
The main LSI Logic Config Utility menu is the first screen you can
navigate that shows you how to configure and use the components of
the LSI Logic integrated raid (IR) software product with LSI Logic
controller — LSI SAS1068E.
To start the LSI Logic Config Utility:
1. Turn on or reboot your system;
2. Press <Ctrl+C> during POST to start the LSI Logic Config Utility;
3. On the Adapter list screen, use the arrow keys to select an LSI Logic
SAS adapter (SAS1068E), as shown in figure X.1;
Figure X.1
4. Press <Enter> to go to the Adapter Properties screen as shown in
figure X.2
114
Summary of Contents for Transport TN27 B4987
