F08 Installation & Programming Manual
Document No: LT0082
Application Considerations
5.1.3
ALARM ON STANDBY - SEPARATE INDICATION TO ALARM
Figure 5.3 shows how two AZC inputs of an F08 can be used to monitor a sub-panel. AZC1
is used for the sub-panel’s Alarm and Fault signals, AZC2 is used for the Standby and
Isolate signals (if required). By the use of the two AZCs the mapping and/or indication of
alarm and standby from the sub-panel can be different. The ALARM, FAULT, ISOLATE and
STANDBY relays should be provided in the sub-panel.
NOTES:
1)
STANDBY is normally energised.
2)
The second AZC can map to the Brigade Relay and/or bells as
required.
3)
SUB-PANEL TO MASTER FIP WIRING MUST BE FIRE RATED
CABLE.
+
-
EOL
NC
COM
FAULT
NO
COM
ALARM
F08
AZC
1
+
-
EOL
NC
COM
ISOLATE
NC
COM
STANDBY
F08
AZC
2
Figure 5.3
Dual Zone Sub-Panel Circuit Wiring
Page 5-4
24 March 2006
Issue 3.04
Summary of Contents for F08
Page 48: ......