7
4.3.7 Pull gently on the fibers in the tray and make sure that the
fibers are well contained in FAS block and wraparound groove plate.
4.3.5 Position the loose tubes in the tube holder and slide the tube
holder retainer with the snap forwards in the lowest possible cavity of
the tube holder above the loose tube(s). The tube holder retainer must
snap.
4.3.8 Store the fibers temporarily on a tray.
5
Pigtail installation
5.1
Installation of pigtails with connectors
4.3.6 Route the fibers in the grooves of the wraparound groove plate
to the entrance of the identified tray. Fiber must be routed in the
groove of the tray hinge.
5.1.1 Connector adapters have to be installed in the patch panel.
Push the adapter from the top in the patch panel and slide it in position.
