4
3.5.3. Hold the base part onto the wall. Insert the screws and tighten.
4.1.1. Feed the cable through the cable port gland.
4
Cable installation
4.1
Cable preparation
4.1.2. In case the cable diameter does not match with the diameter
of the gland seal, remove the plastic nut, metal ring and rubber seal
inside the gland and peel out some of the break out rubber rings up to
the right diameter.
3.5.1. Place the template against the wall and mark the 4 mounting
positions.
3.5.2. Drill the holes (dia. 6 mm, depth 60 mm) and place the plugs
into the holes.
3.5
Mounting of the box on the wall
