PRN800 MX Printer
MZX Fire alarm system
© Tyco Fire & Security GmbH, Victor von Bruns-Strasse 21, 8212 Neuhausen
am Rheinfall, Switzerland
www.zettlerfire.com
120.415.535_17A-03-PRN, doc. version 3, 22. March 2017
Subject to change without notice.
Paper roll replacement
1 Undo the two Supadrive™ screws and
remove the printer mechanism front
cover.
2 Pull out the paper drive spindle.
3 Pull out the paper roll retaining bar and
slide off the old paper roll.
4 Put the new paper roll onto the paper roll
retaining bar with the paper feeding from
the rear.
5 Press the paper roll retaining bar back into
its grooves.
6 Feed the paper over the paper drive spin-
dle and press the spindle back into its
retaining grooves.
7 Feed the paper through the printer mecha-
nism front cover slot and refit the retaining
screws.
Ordering information
Fig. 3: Paper change
1 –Paper drive spindle
2 –Paper roll retaining bar
1
2
Item
Order Code
Spare paper roll (pk of 5)
557.301.014
Fig. 4: Order codes
MZX Fire alarm system
PRN800 MX Printer
Fixing Instructions Doc. version 3
1/4
PRN800 MX Printer
Part No. 557.202.024
The PRN800 is fitted to the front cover of the
MX /T2000 battery housing/MX2 Expan-
sion box housing and is powered from the
panel PSU830 Power Supply via an FB800
fuse board. The use of a thermal printer mech-
anism ensures high reliability, only the paper
roll requires replacement periodically.
Installation instructions
The installation instructions are as fol-
lows:
1 Open the battery/expansion housing
and loosen or remove the relevant
blanking strips holding the top blank-
ing plate onto the front door.
Fig. 1: PRN800 MX printer kit
1 –Paper feed button
1
NOTICE
The PRN800 Printer kit is
designed for use within the MX/
T2000 battery housing and MX2
Expansion box housing.
CAUTION
The printer assembly must be
powered via a FB800 fuse board
using a 0.5 A time delay fuse.
A free cable entry hole is required
in both the controller and battery/
expansion housings.
Any cable runs must be protected
by conduit or trunking.
