BATTERY CHARGING/CARE - 6.0V JET TURBO BATTERY
(BATTERIES AND CHARGER NOT INCLUDED]
TRANSMITTER
POWER OPTION TWO - 6.0V JET TURBO
RECHARGEABLE NiCD BATTERY PACK
Estimated run time with 6.0V Jet Turbo Battery Pack: 25-30 minutes per full charge.
Please read “Battery Charging/Care”
on the next page.
1.
Release battery compartment latch.
2.
Insert battery pack into battery compartment and slide battery pack
toward thumb slot. Turn latch to lock.
3.
To remove battery pack: turn latch, slide battery pack toward latch
and lift out.
1.
Slide lid of Power Clip in direction of arrows to open.
Insert 4 “AA” batteries, with polarity (+/-) as shown
inside Power Clip. Replace lid.
2.
Release battery compartment latch.
3.
Insert Power Clip into battery compartment and slide
Power Clip toward thumb slot. Turn latch to lock.
4.
To remove Power Clip: turn latch, slide Power Clip
toward latch and lift out.
1.
Slide battery door open.
2.
Install one 9-volt battery with polarity (+/-) as shown inside battery compartment.
3.
Replace battery door.
POWER OPTION ONE - 6.0V DP POWER CLIP
POWER OPTION ONE - 6.0V DP
POWER CLIP
(4 “AA” BATTERIES NOT INCLUDED)
POWER OPTION TWO - 6.0V JET TURBO
RECHARGEABLE NiCD BATTERY PACK
■
Do not mix old and new batteries.
■
Do not mix alkaline, standard (carbon-zinc), or rechargeable (nickel-cadmium) batteries.
■
Remove batteries if vehicle will not be used for a long period of time.
■
For best performance, we recommend alkaline batteries.
Battery Contacts
■
Bent or dirty contacts may result in loss of power.
■
If battery does not fit correctly, gently bend back metal contact as shown in diagram.
IMPORTANT BATTERY INFORMATION
metal contact
TRANSMITTER
Estimated run time with 6.0V DP Power Clip: 80-90 minutes per set of batteries.
NOTE:
The “AA” batteries used in the 6.0V DP Power Clip will gradually lose power over their lifetime. You will notice a decrease in performance as this
occurs. The 6.0V Jet Turbo rechargeable NiCd battery pack will run at a sustained high power level for virtually its entire run time.
BATTERY CHARGING/CARE - 6.0V JET TURBO BATTERY
(BATTERIES AND CHARGER NOT INCLUDED]
TM
■
This economical system is the only rechargeable NiCd battery
pack and charger made to power your Tyco
®
R/C vehicle.
■
Rechargeable up to 1000 times!
■
This vehicle uses a Nickel-Cadmium rechargeable battery pack.
Must be recycled or disposed of properly.
1.
Plug wall pack charger into standard wall outlet.
2.
Click the battery pack into the charger. Make certain the battery
pack is secure in charger.
3.
To disconnect, push the red button on the side of charger and
simultaneously slide battery pack out.
4.
After charging for 4 hours, the battery will feel warm. This
condition is normal for fully charged batteries.
5.
New battery packs must be charged for 5
1
⁄
2
hours the first two
times charged. Subsequent charges will require only 4 hours.
Charging the battery pack for more than 4 hours will not give you
a longer running time. 4 hours is all that is required for a fully
charged battery pack.
6.
Unlike alkaline batteries, where the power loss is gradual, a NiCd
(Nickel-Cadmium) battery will run for its normal running time
and then lose most of its power at once. It is now time to recharge
the battery pack.
7.
After use, the battery pack will be hot! Wait at least 20 minutes
until the battery pack cools before recharging. Recharging a warm
or hot battery pack will greatly reduce the number of times your
battery pack can be recharged.
®
®
Thumb
Slot
Thumb
Slot
