6
2.
CAPACITY:
The UPSPro UPS-ST12 is rated at 144W load output.
The UPS-ST24 is rated at 192W load output. The UPS –ST24 can de-
liver 288W to the load but then the power available for battery charging
is too small, so we recommend not to exceed 192W to the load for best
performance.
3.
VENTING:
The enclosure is vented thru the wire feedthrus and vari-
ous hole plugs in the bottom of the enclosure. Don’t make these airtight
with silicon
4.
BATTERY MAINTENANCE:
The batteries used in the UPSPro sys-
tems don’t require any maintenance. They should last up to 5 years in
normal use.
5.
BATTERY OVERDISCHARGE
: We highly recommend hooking all
equipment loads to the controller voltage output. This output will discon-
nect the load if the battery voltage drops below the set voltage and this
will protect the battery from over-discharge. If batteries get completely
discharged because the equipment was connected directly to the bat-
SPECIFICATIONS
Subject to change without notice
UPS-ST12
UPS-ST24
Load Voltage (DC)
12V +/-5%
24V +/- 5%
Max Load Output
12A
12A
Min Load Output
1A
1A
Available Storage
Capacities
1 battery 51Ah 600VA
2 battery 102Ah 1200VA
4 battery 204Ah 2400VA
2 battery 51Ah 1200VA
4 battery 102Ah 2400VA
Battery Type
Valve Regulated Sealed
Lead Acid / GEL
Valve Regulated Sealed
Lead Acid / GEL
Battery Life
5 Years
5 Years
Charge Voltage
WET Equalize = 14.6V,
Float = 13.2V
GEL Equalize = 14.2V,
Float = 13.5V
WET Equalize = 28.8V,
Float = 26.4V
GEL Equalize = 28.4V,
Float = 27V
Over-discharge
protection
10.7V Load Off
12.6V Load On
21.5V Load Off
25.2V Load On
VAC Input +/- 10%
Selector Switch
120VAC / 240VAC ,
50/60Hz
Selector Switch
120VAC / 240VAC ,
50/60Hz
VAC Input Current
3.5A @ 115VAC / 1.8A
@ 240VAC
3.5A @ 115VAC / 1.8A
@ 240VAC
Enclosure Type
Powder Coat Steel
Powder Coat Steel
Operating Temper-
ature
-30°C to +60°C
-30°C to +60°C
