8000060 Rev 1 23-Feb-18
15
PRESSURE SETTING
Under setting mode, the first setting function appear on message board is
”TIME
SETTING
”. Press”
”button repeatedly to switch to “BAROMETRIC SETTING” display.
Then press the
” ” button to select the desired sub functions:
a) CURRENT WEATHER: Press
/
buttons to adjust the weather forecast icon on
display.
b) BAROMETRIC PRE-SET: Press
/
buttons to change the barometric pre-set
threshold from 2 to 4hPa/hr.
The lower the pressure pre-set value setting, the higher sensitivity for weather forecast
changes. Locations that experience frequent changes in air pressure require a higher
setting compared to locations where the air pressure is typically stagnatnt..
c) BAROMETRIC PRE-STORM: Press
/
buttons to change the barometric
pre-storm threshold from 3 to 8hPa/hr.
When there is a fall over pressure threshold in 3 hours, the storm forecasting will be
activated, the clouds with rain icon will flash for 3 hours indicating the storm warning
feature has been activated.
d) BAROMETRIC COORDINATES: Press
/
buttons to change the historical
graph time between 12 and 24 hours.
KEY BEEP SETTING
Under setting mode, the first setting function appear on message board is
”TIME
SETTING
”. Press”
”button repeatedly to switch to “BUTTON BEEP SETTING” display.
Use the
” ” button to start setting button beep.
Press
/
buttons to switch on/off the button beep.
Calibration setting
a) LIGHT FACTOR
LUX index calibration coefficient: default 1. (Range is 0.1-10)
b) UV FACTOR
UV factor calibration coefficient: default 1 (Range is 0.1-10)
c) IN TEMP OFFSET
Offset for indoor temperature.
d) IN HUMI OFFSET
Offset for indoor humidity.
e) OUT TEMP OFFSET
Offset for outdoor temperature.
f)
OUT HUMI OFFSET
Offset for outdoor humidity