1
30
31
System Setup Method
H Level Adjustment
H Level Adjustment
p
System Setup Method
Color of pH testing of each level:
When testing the pH, be sure to allow the unit to run for 1 minute (60
seconds) before taking a sample of the water. If you have to adjust the
percentage, after adjusting, run an additional 1 minute before taking a new
sample. When testing pH values, we like to use 2 tablespoons (30mL) of
the water being produced and 4 drops of the reagent in a clear glass. The
minimum and maximum Turbo waters produced will depend on the water
source quality. Set Turbo at 99% for maximum pH levels. These levels can
range normally as follows:
Alkaline Turbo (dark purple)
Acidic Turbo (red)
Alkaline Level 1 Approx. 8.0-8.5 pH (light blue)
Alkaline Level 2 Approx. 9.0 pH (light purple)
Alkaline Level 3 Approx. 9.5 pH (purple)
H2O = Approx. 7.0 pH (green) Purified Water
Acid Level 1 Approx. 6.5~5.5 pH (light greenish yellow)
Acid Level 2 Approx. 5.5~4.0 pH (light orange)
Acid Level 3 Approx. 4.5~3.5 pH (dark orange)
※The
pH value indicated for each level is based on standardized test results which have used average tap water.
H Level Adjustment
p
ystem Setup Method
S
p
Press
ALKALI pH.
Press the desired level that you
would like to adjust. (level will
highlight in blue)
3
4
1
Press the setup icon.
2
Press the top left corner of the screen. The menu
options will fall below the upper part of the screen.
ALKALI pH Level Adjustment
Push the RETURN icon for the previous menu screen. Voice says: “
Applied
”
Push the RETURN icon again to complete setup. Voice says: “
Setup was completed
”
If you push the UP/DOWN icon, the digital number will increase or decrease by one level.
With the desired level highlighted press to raise the percentage
of power or press to lower the percentage of power for that level.
Pressing either arrow once will change the value by 1% in that
direction. Holding the arrow will cause the percentage to change
continuously until the arrow is released.
When done push the RETURN icon for the previous menu
screen. Voice says: “Applied”
Then push the RETURN icon again to leave System Setup.
Voice says: “Setup was completed”
*VALUES SHOWN ARE EXAMPLES ONLY AND
ARE NOT TO BE TAKEN LITERALLY*
pH Chart
4.0
2.5
11.5