W a t e r H o s e Installation
W a t e r H o s e Installation
W
at
er
Hose
Inst
all
at
ion
W
at
er
Hos
e
Ins
ta
lla
tion
W
ater Hose Installation
Inflow
①
Place the unit on the planned installation
location and screw the flexible tube clockwise
into the water outlet hole positioned at the top of
the unit. Do not over tighten.
②
Press the stem elbows into the water inflow
and
outflow holes on the bottom of the unit until you
hear a click and feel the hose sit firmly in place.
⑤
Cut an appropriate length of drain hose and
connect it the drain faucet. When drain hose is
connected, put the drain faucet in the inner part
of sink to run water.
⑥
Install the drain faucet near sink and adjust the
position of drain faucet to drain away to the sink.
⑦
Turn on both the cold and hot water supply.
Make sure there are no leaks at any of the
connections. Make sure the faucet is working
with both hot and cold water. Make sure there
are no leaks from the hose connections on the
bottom of the unit. Make sure the hoses are firmly
seated in the unit holes.
③
Measure between where the unit will be located
(on the counter) and the water faucet (or under-
sink T-connection) where the diverter (or T-
connection) will be installed. Cut enough hose to
allow connection from the rear of the unit to the
water supply (either faucet diverter or under-
sink T-connection).
Note:
Keep the length under-16 feet (5 meters) from
the unit to the faucet. You may need a pressure pump
or larger size hose if the pressure is too low. Be sure to
leave a few extra inches (centimeters) of length so the
faucet can still be rotated.
④
Connect the hose from the inflow hole to the
cold water supply, either at the faucet diverter
(Option
A - remove the nut from the diverter,
slide the nut on to the hose, firmly seat the hose
on the faucet diverter, and screw the nut over
the hose and back on to the faucet diverter) or the
under-sink T-connection.
(
Option B:
route the hose through the counter-top
to the T-connection, firmly seat the hose on the
T-connection, make sure the connection is sealed
completely)
Inflow
Drain
hose to faucet
⑧
Plug in the power cord. You should hear a
series of tones when you power up the unit.
※
Be careful not to touch the touch screen at initial
power up. The touch sensor may not operate caused
by touch sensibility change. If the touch sensor does
not operate due to contact with a part of the body,
reconnect the power cord.
Drain faucet
to sink
Drain
18
19
