L A S E R S F O R M A R K I N G
Introduction
Let’s Get Started!
Thank you for purchasing the TYKMA
™
Zetalase
™
Laser Marking System. Ideal for
single or multiple part marking on all metals, hard plastics, and painted or anodized
materials. Mark text, graphics, barcodes, 2D, Data Matrix
™
, UID codes and much
more.
In the past, laser marking sytems have required elaborate, time consuming set-up,
plux complex assembly and training sessions. But simple, powerful, affordable laser
systems from TYKMA
™
come fully assembled and can be up and running within an
hour.
If, at any time, you experience difficulties or have installation or operation questions,
please call TYKMA
™
24/7 - toll free at 877-318-9562 for technical assistance.
Zetalase
™
is shipped fully assembled. If, however, your unit is customized with a
rotary, Fumex Air Filtration unit, or other part handling equipment, those items need
to be installed separately.
First, unscrew the crate side panels and packing. Using a pallet jack or fork lift, raise
the pallet carefully and move it to the work area. Zetalase
™
is a tabletop or
workbench system, so you will need a sturdy 40” wide x 26” deep workbench with
the following access area: at least 70” of headroom, and an additional 180
°
radius of
26” on the left side of the system to accommodate access door swing. The unit
weighs approximately 300lbs, so four people will be needed to lift the Zetalase
™
from the pallet and set it in place.
Once set in place remove the protective sheet wrap from the machine. Please
locate the following items included inside of your Zetalase and set aside for
installation:
LIFT ZETALASE™ FROM THE BOTTOM BASEPLATE ONLY. DO NOT PUT ANY
PRESSURE ON THE FRONT OR SIDE ACCESS DOORS TO AVOID DAMAGING THE
FRAME. THE NON-LIFT POINTS ARE CALLED OUT AND LABELED ON YOUR
ZETALASE™ SYSTEM.
Ÿ
Ÿ
Ÿ
Ÿ
Ÿ
Ÿ
Ÿ
Ÿ
Ÿ
Ÿ
Ÿ
One (1) Power Cord
One (1) USB Keyboard
One (1) USB Mouse
Two (2) Laser Enable Keys
One (1) USB Stick (with Manuals & Software)
Zetalase
™
14
General Manual SE 1
