Tyler Advantage NFNX, Installation & Service Manual

NFNX, NCNX, NFNGX,

NCNGX

Installation & Service Manual

CLEANING AND SANITATION

Component Removal and
Installation Instructions for
Cleaning

Bottom Trays

1. Remove product from bottom of case.

2. Grasp and lift out each of the bottom trays

from the case interior and carefully
remove through the door openings

3. After cleaning, replace in reverse order.

NSF Product Thermometer

Remove four screws and product thermome-
ter bracket assembly from right rear location
in the case.  After cleaning, replace product
thermometer bracket assembly and secure
with four screws.

Discharge Air Honeycomb

1. Remove screws and bottom retainer strip

from front or rear interior of case.

NOTE

Note position of the honeycomb grid 
during removal so it can be reinstalled 
the same way.

2. Remove honeycomb grid sections from

the front or rear duct.

CAUTION

Improper installation of the honeycomb
grid section could result in improper air
flow and/or poor refrigeration.

3. After cleaning, replace honeycomb grid

sections as they were removed and
secure with the bottom retainer strip and
screws.

Rear Air Duct Panels

1. Remove bottom trays and discharge air

honeycomb, see this page.

2. Remove mounting screws from rear duct

panel.

3. After cleaning, replace in reverse order.

Front Air Duct Panels

1. Remove bottom trays, see this page.

2. Remove screws and front air duct panels

from case.

3. After cleaning, replace in reverse order.

Corner Trim

1. See page 14 for corner trim removal

instructions.

2. After cleaning trim and cladding compo-

nents, replace front cladding and corner
trim components in reverse order using
instructions below and on page 14.

Front Cladding

1. Remove kickplates and raceway covers

from front of case.

2. Remove screws from bottom and top of

front cladding and pull cladding down to
remove it from behind the bottom edge of
the bumper retainer.

3. After cleaning,  replace front rear cladding

and remaining components in reverse
order.

Page 13

November, 2007