Tyler Advantage NFNX, Installation & Service Manual

Corner Trim Replacement

(NFNX/NCNX/NFNGX/NCNGX with 
Wrap Ends)

Since some of the corner trim fasteners are
hidden, remove the trim and hardware in the
following sequence.

1. Remove mounting screws, kickplate 

corner trims (2) and kickplates (1) from
the case.

2. Remove raceway covers (3) from both

sides of the corner trim.

3. Remove four screws (4) and cladding 

corner trim (5).

4. Remove two top screws (6) from raceway

corner trim (7), then lift and remove the
raceway corner trim (7) from the retainers
in the bottom slots.

5. Remove two bottom screws (8) and lift 

off the bumper corner trim (9).

6. Replace bumper corner trim, raceway 

corner trim, corner cladding trim, raceway
covers, kickplates and kickplate corner
trims in reverse order.

SERVICE INSTRUCTIONS

See “General-UL/NSF I&S Manual” for fan
blade and motor replacement, color band
and bumper replacement and raceway
cover removal instructions.

NSF Product Thermometer
Replacement

1. Remove four screws (1) and thermometer

bracket (2) from rear of case.

2. Remove two screws, nuts, washers and

the product thermometer (3) from the
thermometer bracket (2).

3. Install and secure a new product ther-

mometer (3) on the thermometer bracket
(2) with two screws, washers and nuts.

4. Install thermometer bracket (2) on rear of

case with four screws (1).

November, 2007

Page 14

NFNX, NCNX, NFGNX,

NCNGX