Installing/Replacing Batteries
1. Slide and remove the battery cover (Fig.1).
2. Install batteries with the + and – ends matching indication marks
on the battery compartment (Fig.2).
3. Slide battery cover back into place (Fig.3).
Date/Time Setup
1. When the meter is off, press and hold for 4 seconds to enter this setting mode.
2. Press or to select “24hr” or “12hr”.
3. Press to confirm (Fig.4).
4. The numbers of “year” will appear and flash. Press or to adjust and Press to confirm (Fig.5).
5. The number of “month” will appear and flash. Press or to adjust and press to confirm (Fig.6).
6. The numbers of “date” will appear and flash. Press or to adjust and press to confirm (Fig.7).
7. The numbers of “hour” will appear and flash. Press or to adjust and press to confirm (Fig.8).
32
32
Setting Up Tyson Bio HT100-B Blood Glucose Meter
˙
Make sure the batteries are properly installed
˙
The default is set to January 1st, 0:00
˙
Please follow instructions to properly setup the meter
(Fig.2)
(Fig.1)
(Fig.3)
(Fig.4)
(Fig.5)
(Fig.6)
(Fig.7)
(Fig.8)
08
