Easy Travel
– Service Manual
Rev. 0401
33
c. Take up the slack in the Cable and
tighten the first Lock against the
Bracket (32-H)
d. Push the Spring (31-B) and Lock Pin
(31-A) into the Housing (31-D) so that
the end of the Pin is flush with the end
of the Housing
e. Thread the second Cable Lock (32-L)
onto the Cable, take up the slack and
tighten the Lock against the Bushing
(32-L)
f. Trim the Cable to approximately 20
mm. and crimp the Cable End Cone
(32-M) onto the end of the Cable
8. For Seat model E0-00-1-201:
a. Insert Cable through Cable Stops (33-
A) in Cable Holder (33-B), ensure that
the Cable does not slack and close
Cable Stops
NOTE: Seat Backrest needs to be in an
upright position
NOTE: Keep Cable Holder in place with
a small rod (diameter 15 mm)
b. Secure End (33-C) with Cable End
Stopper (33-D); ensure that the bend
is outwards
c.
Place Cable Holder with Stud in
Groove (33-E)
d. Place Pivot Cap (33-F) over Cable
Holder
e. Apply some Loctite in Nut (33-G) and
screw on Pivot Screw (33-H)
f. Apply some Loctite in Nut (33-J)
g. Assemble Pivot Cap (33-F) with Pivot
Screw (33-H) and secure with Nut
(33-J)
9. Test the efficiency of the assembly by
unfolding the Frame Assembly, adjust
as necessary
Figure 33
Summary of Contents for Easy Travel Elite
Page 1: ...Service Manual...
