Lexis Light
–
ET1B
User’s Manual T. Rev. 0512 PM 11
Blinking - Needs Charging
BATTERY
FORWARD
REVERSE
SPEED
LO
HI
BATTERY
REVERSE
FORWARD
SPEED
Blinking - Needs Charging
LO
HI
BATTERY
REVERSE
FORWARD
SPEED
Blinking - Needs Charging
LO
HI
Indicator light flashes
– This indicates a possible fault. Please
follow the following procedure:
1. Switch off the
Lexis Light
2. Make sure that the
Lexis Light
is not in the
FREEWHEEL position.
3. Make sure that the charger is not connected to the
Lexis Light
4. Make sure that the control lever is in the middle position.
CAUTION:
If control lever does not return by itself to the middle
position - do not operate. Contact your service agent.
5. Switch the
Lexis Light
on again and check the indicator
light. If it flashes rapidly again, switch off and do not operate.
Contact your service agent!
5.3. Battery Gauge (Fig. 9/5)
The Battery Gauge (Fig. 9/5) shows the battery charge that is left.
5.4. Driving your
Lexis Light
To drive forward, pull the right side of the hand control lever towards you
(Fig. 10/1). You can also move forward by pushing the left side of the
control lever away from you. By releasing the control lever, you will
gradually come to a stop, and the
Lexis Light
brake will be
applied automatically. To operate in reverse, pull the left side of the hand
control lever towards you (Fig. 10/2).
Figure 10
