1. Download the EVK-M8230 software (and docu-
mentation) from www.u-blox.com/evaluation-kits
and install the software. For more instructions, see
section 5, Installation.
2. Connect the EVK to PC. Options:
• USB: Connect via USB port (
B
). Set switch (
D
) to
RS232/USB.
• UART: Connect via RS232 (
C
). Set switch (
D
) to
RS232/USB.
Note: The Windows system will automatically search
for and install USB driver.
3. Provide power to the device at all times, either via
USB or the 5V_CON pin on the 20-pin connector (
G
).
4. Connect antenna signal to EVK via RF IN (
A
).
5. Start the u-center GNSS Evaluation Software and
select the corresponding COM port and baud rate.
Quick Start EVK-M8230
2. Setup
Copyright © 2017, u-blox AG
1. Overview
A (RF IN)
B (USB)
C (RS232)
F (RST)
G (20-pin
connector)
D (SPI or RS232/USB switch)
E (Boot)
Plastic
protection cover
