LARA-R2 series - System Integration Manual
UBX-16010573 - R12
Design-in
Page 123 of 157
2.11
Module footprint and paste mask
Figure 68 and Table 50 describe the suggested footprint (i.e. copper mask) and paste mask layout for LARA
modules: the proposed land pattern layout reflects the modules’ pins layout, while the proposed stencil apertures
layout is slightly different (see the F’’, H’’, I’’, J’’, O’’ parameters compared to the F’, H’, I’, J’, O’ ones).
The Non Solder Mask Defined (NSMD) pad type is recommended over the Solder Mask Defined (SMD) pad type,
implementing the solder mask opening 50 µm larger per side than the corresponding copper pad.
The recommended solder paste thickness is 150 µm, according to application production process requirements.
Foot-print
Top View
K
M1
M1
M2
E
H’’
J’’
E
B
K
G
H’’
J’’
D
A
D
O’’
O’’
L
N
L
I’’
F1’’
F2’’
G
G
H’’
H’’
H’’
G
G
Pin 1
ANT1
ANT2
K
M1
M1
M2
E
H’
J’
E
B
K
G
H’
J’
D
A
D
O’
O’
L
N
L
I’
F1’
F2’
G
G
H’
H’
H’
G
G
ANT1
ANT2
Pin 1
Paste-mask
Top View
J’
J’
J’’
J’’
Figure 68: LARA-R2 series modules suggested footprint and paste mask (application board top view)
Parameter
Value
Parameter
Value
Parameter
Value
A
26.0 mm
F2’’
5.00 mm
K
2.75 mm
B
24.0 mm
G
1.10 mm
L
6.75 mm
C
2.60 mm
H’
0.80 mm
M1
1.80 mm
D
2.00 mm
H’’
0.75 mm
M2
3.60 mm
E
6.50 mm
I’
1.50 mm
N
2.10 mm
F1’
1.05 mm
I’’
1.55 mm
O’
1.10 mm
F1’’
1.00 mm
J’
0.30 mm
O’’
1.05 mm
F2’
5.05 mm
J’’
0.35 mm
Table 50: LARA-R2 series modules suggested footprint and paste mask dimensions
These are recommendations only and not specifications. The exact copper, solder and paste mask
geometries, distances, stencil thicknesses and solder paste volumes must be adapted to the specific
production processes (e.g. soldering etc.) of the customer.
