LILY-W1 series - System integration manual
UBX-15027600 - R09
System description
Page 8 of 64
C1 - Public
switched off. Only a slow sleep clock is used to maintain register and memory
states. Wake-up does not require a firmware re-download.
IEEE Power Save
(Station mode
only)
The device automatically wakes up on beacons. This is dependent on the DTIM
value of the AP it is connected to. If the DTIM value is 1 along with a beacon interval
of 100 ms, the device wakes up every 100 ms. Similarly, for DTIM =2, the device
wakes up at every 200 ms, and so on.
Receive Idle /
AP Beaconing
DUT is powered on and had completed firmware download. DUT is ready to receive
packets, but is not actively decoding any because none are being transmitted to it.
Active
Tx/Rx data connection enabled and system runs at specified power consumption.
Table 2: Description of operation modes for LILY-W1 series
1.2
Pin configuration and function
1.2.1
Pin attributes
The pin attributes described in Table 3 are:
1.
Function:
Pin function.
2.
Pin name:
The name of the package pin or terminal.
3.
Pin number:
Package pin numbers associated with each signals.
4.
Power:
The voltage domain that powers the pin
5.
Type:
Signal type description:
-
I = Input
-
O = Output
-
I/O = Input and Output
-
D = Open drain
-
DS = Differential
-
PWR = Power
-
GND = Ground
-
PU = Internal Pull-Up
-
PD = Internal Pull-Down
-
H = High-Impedance pin
-
RF = Radio interface
6.
Signal name:
The signal name for that pin in the mode being used.
7.
Remarks:
Pin description and notes.
