MAX-7 / NEO-7 / LEA-7 - Hardware Integration Manual
GPS.G7-HW-11006-1
Product handling
Page 45 of 55
others) is the risk of the module falling off due to the significantly higher weight in relation to other
components.
Two reflow cycles can be considered by excluding the above described upside down scenario and taking into
account the rework conditions described in Section
Repeated reflow soldering processes and soldering the module upside down are not recommended.
5.2.6
Wave soldering
Base boards with combined through-hole technology (THT) components and surface-mount technology (SMT)
devices require wave soldering to solder the THT components. Only a single wave soldering process is
encouraged for boards populated with u-blox 7 modules.
5.2.7
Hand soldering
Hand soldering is allowed. Use a soldering iron temperature setting equivalent to 350 °C and carry out the hand
soldering according to the IPC recommendations / reference documents IPC7711. Place the module precisely on
the pads. Start with a cross-diagonal fixture soldering (e.g. pins 1 and 15), and then continue from left to right.
5.2.8
Rework
The u-blox 7 module can be unsoldered from the baseboard using a hot air gun. When using a hot air gun for
unsoldering the module, max one reflow cycle is allowed. In general, we do not recommend using a hot air gun
because this is an uncontrolled process and might damage the module.
Attention: use of a hot air gun can lead to overheating and severely damage the module.
Always avoid overheating the module.
After the module is removed, clean the pads before placing and hand soldering a new module.
Never attempt a rework on the module itself, e.g. replacing individual components. Such
actions immediately terminate the warranty.
In addition to the two reflow cycles, manual rework on particular pins by using a soldering iron is allowed. For
hand soldering the recommendations in IPC 7711 should be followed. Manual rework steps on the module can
be done several times.
5.2.9
Conformal coating
Certain applications employ a conformal coating of the PCB using HumiSeal
®
or other related coating products.
These materials affect the HF properties of the GPS/GNSS module and it is important to prevent them from
flowing into the module. The RF shields do not provide 100% protection for the module from coating liquids
with low viscosity; therefore, care is required in applying the coating.
Conformal Coating of the module will void the warranty.
5.2.10
Casting
If casting is required, use viscose or another type of silicon pottant. The OEM is strongly advised to qualify such
processes in combination with the u-blox 7 module before implementing this in the production.
Casting will void the warranty.
5.2.11
Grounding metal covers
Attempts to improve grounding by soldering ground cables, wick or other forms of metal strips directly onto the
EMI covers is done at the customer's own risk. The numerous ground pins should be sufficient to provide
optimum immunity to interferences and noise.
u-blox makes no warranty for damages to the u-blox 7 module caused by soldering metal cables or any
other forms of metal strips directly onto the EMI covers.
