5
110V/220V
BATTERY CHARGING USING INSTRUCTIONS
1. When playing the drone,please connect the drone’s power with two wires( positive and negative pole )
to the battery with two wires(positive and negative pole). (figure 1).
2. When charging,please unplug the two wires (positive and negative pole) plug at first,then connect the
drone’s three wires plug to the charger. (figure 2).Remarks:Red LED is lighting up while charging.After
charging completely.Then the LED extinguish to green.The charging time is about 180 mins.
Distance of 3M
Distance of 2.5M
Distance of 3M
Distance of 2M
Distance of 3M
Warning on Li-poly battery:
1. Do not put the battery into fire or heat source.
2. Keep the battery away from heat source, and do not use it by the side of heat source.
3. Do not place the battery on the surface of hot matter.
4. Do not soak the battery in water and keep it in a dry and low-temperature environment.
5. Only the charger specified for the product can be used for charging the battery.
6. Do not over-charge the battery.
7. Do not connect the battery with other circuit.
8. Do not fix battery with bolt or any sharp matter.
9. Do not place the battery together with metal parts or jewelry.
10.Do not disassemble the battery.
11.Charge the battery at least once per six months.
12.Turn off the power of product immediately after using.
13.After use the battery,please use PE bags to wrap or use insulation sheet to isolation
battery positive and negative.
Environment for flight
Do not fly in extreme temperature. Do not fly in temperature above 113 degrees Fahrenheit/45 degrees
centigrade,or below 50 degrees Fahrenheit/10 degrees centigrade.Flying in extreme heat and/of cold
will affect performance and may damage the model.
Do not fly in strong wind. Windy conditions will limit,or disturb the flying control.In very windy conditions,
your drone may become lost and/or damaged.
2.Select large,wide-open area for flying,and make sure there is no obstacles,animals or people nearby.
1.Fly on a sunny day,without wind.
1
2
ͧLOM[XKͨ
Battery holder
Battery Socket
Drone
socket
ͧLOM[XKͨ
1. Before charging,the drone shall be stopped for 10-15 minutes to ensure the inbuilt
Li-poly battery is cooling completely.
2. Before continuous flight, the drone shall be stopped for 10-15 minutes to ensure the
inbuilt motor is cooling completely.
Notes:
7.4V 1800 MAH Li-po battery
