CALIBRATION METHOD
1.When the hexacopter appear rotation flying and blades can not normal rotate.Put
the hexacopter in the horizontal place,calibrate the transmitter,move both joysticks
simultaneously down and to the right to their maximum positions. At this time,
hexacopter light flashing, let go of the joysticks. It means calibration successful.
2.when the hexacopter has been in a direction rotation or move,controller trim is
also can not be transferred to the midpoint. Meanwhile,calibrate the transmitter,
move throttle joystick down and put the direction joystick up to the right to their
maximum positions. At the same time, turn off the switch and then turn on. Hear
the continuous sound beep beep twice,on behalf of the trim calibration successful.
3. When start headless mode, the orientation of hexacopter is confuse. Put the
hexacopter head in the specified direction, then using a connected frequency
controller to calibrate the transmitter. Move both joysticks simultaneously
down and to the left to their maximum positions. At this time, hexacopter light
flashing, Let go of the joysticks. It means headless mode calibration successful.
SPARE PARTS
Part-01 Part-02 Part-03
Upper Body Down Body
Part-04 Part-05 Part-06
Main Blade A /B 2.4G Remote Controller Charger
Part-07 Part-08 Part-09
Landing Gear Main Frame
Part-13
Part-10 Part-11 Part-12
Main Motor Main Motor(Red/Blue Wire) Main Motor(Red/Black Wire)
7.4V 1800 MAH Li-po battery
PCB Board
Motor cover up and down
Part-14
5.8Ghz FPV LCD Screen
