SAFETY •
INSTALLATION & INTEGRATION
• OPERATING INSTRUCTIONS • MAINTENANCE • SERVICE
USER GUIDE
u-line.com
Anti-Tip Bracket
1.
Slide unit out so screws on top of unit are easily
accessible.
2.
Remove the two screws from the opposite side of
the hinge assembly using a T-25 Torx driver (see
below).
NOTE: 1224 models shown with four screw. 1215
models only have three screws, but same screws are
used in both applications.
unit with two screws removed in step 2 using a T-
25
Torx driver. Tighten screws fully.
4.
Gently push unit into position. Be careful not to
entangle the electrical cord or water line, if
applicable.
5.
Check to be sure the unit is level from front to
back and side to side. Make any necessary
adjustments. The unit’s top surface should be
approximately 1/8" (3 mm) below the countertop.
6.
Secure bracket into adjoining surface.
