U-Line 2175BEVOL, Use And Care Manual

16

2175BEVS, 2175BEVOL

Light Bulb Replacement

To replace the light bulb in your U-Line unit:

Figure 16

1. Grasp the edges of the light housing lens 

(Figure 16, 1)

 opposite the exposed tab and gently 

push the lens toward the tab 

(Figure 16, 2)

.

2. Pull the edge of the lens down 

(Figure 16, 1)

 and 

swing it out of the light housing.

IMPORTANT

IMPORTANT

ALWAYS use a genuine U-Line replacement bulb (P/N 
31317) in the light housing. Use of any other bulb 
within the housing will generate excessive heat, 
causing damage to the light housing and cabinet 
interior, and will compromise the precise 
temperature control of your unit.

3. Replace the bulb only with a genuine U-Line P/N 31317 

replacement.

4. Replace the lens by first inserting the tab side back into 

the housing at a slight angle. While gently pushing the 
lens towards the tab end, push the free end up into the 
housing, and release when you will hear a snap/click.

Wine Rack Removal/Installation

To remove a rack from the cabinet: 

1. Grasp the end of the rack, and gently slide it out until 

it stops.

2. Remove any bottles stored on the rack.

Figure 17

3. Press the left rack release lever 

(Figure 17)

 down, and 

at the same time, lift the corresponding right rack 
release lever up, and pull the rack out until it is free of 
the tracks and the cabinet.

IMPORTANT

IMPORTANT

Do not remove the track side rails from the cabinet.

To insert a rack in the cabinet:

1. Align the left and right rack channels with the tracks 

in the cabinet, and ensuring an even track 
engagement on both sides, gently push the rack into 
the cabinet until it stops.

2. Before reloading the rack, ensure proper operation of 

the travel stops in the left and right track rails by 
pulling the rack out gently until it completely stops.

1

2

ULIN_0001_A

ULIN_0162_A

ULIN_016357_30172.fm  Page 16  Friday, February 2, 2007  11:45 AM